Setting up roofing tiles could be a strenuous job and must not be tried if you do not know exactly what you are doing. It is important to make sure that you establish enough roofing system prep work prior to installing roofing tiles. Otherwise, you are running the risk of the integrity of your brand-new roofing.
An improperly prepared roofing could easily cause openings and also fractures that will cause a dripping roofing system. Clearly, the very first component of your roof covering prep work prior to mounting roofing tiles is to remove the hold or damaged tiles that you are changing. While it is possible to leave these on even if they are showing signs of damages, you must change them whenever possible.
What To Do Before Installing Roof Shingles
Protect the roof covering boards
If you are using the same roofing system boards without changing them, you need to inspect all to ensure if they need replacement. See to it they are all firmly attached to avoid any kind of damages to the lining or to the tiles. You also have to see to it that no particles exist since this could also trigger damages to your brand-new roof covering. See to it no nails or various other things are extending from the roofing system.
Mounting the drip side
Mount the drip edge around the eave finishes of the roofing. Be sure to use galvanized nails to avoid rusting in the rain. When including the drip edge to the top of the roof, set up similarly. However, the roof has to drape over the remainder of the drip side to be effective. If you should make any kind of joints because the size of drip side is not long enough to fit down the entire size of the eave, then just overlap both pieces and flex the lightweight aluminum right into place.
Ice and also water guard
You should also consider taking down a layer of ice and water guard. Some states need you to utilize this and set up ranges that the guard has to be from the wall surface. Once the guard is glued, there is no way of removing it. Ice, as well as water guard, will certainly cost you a reasonable amount but the work it does is very useful. Putting these guards is a crucial step when you are completing your roofing prep work prior to mounting roofing shingles. Cover any type of big knot openings with lightweight aluminum flashing or a comparable product as well as hammer these down.
Adding a layer of felt
Overlap the felt by a few inches and cover one side of the roofing system entirely. To mount a roofing air vent, at this moment, you must cut a tiny part of the roofing which is practically the entire size of the roof covering. Then cover the remaining side of the roof covering with felt and cover the roofing system duct opening you have produced. This will be cut later on. You have just completed the roof covering prep work prior to mounting roofing shingles and now you are ready to tile your roofing.
Have your roof prep done by professionals at Florence Roofing Experts. Call now!
Florence Roofing Experts
2117-B W. Palmetto Street #103
Florence, SC 29501